Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Increase the separation between the equipment and receiver. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. WARNING: This product may contain chemicals known to the State of California to cause cancer, or birth defects or other reproductive harm.įCC StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.This symbol indicates that a dangerous voltage constituting a risk of electric shock is present within this unit.These stickers are located on the bottom of the mixer. The symbols shown below are internationally accepted symbols that warn of potential hazards with electrical products. Refer servicing to qualified service personnel. WarningTo reduce the risk of electrical shock, do not open the unit. Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Equipment may be located above or below thisĪpparatus, but some equipment (like large power amplifiers) may cause an unacceptable amount of hum or may generate too much heat and degrade the performance of this apparatus. If rack-mounting, provide adequate ventilation. When permanently connected, an all-pole mains switch with a contact separation of at least 3 mm inĮach pole shall be incorporated in the electrical installation of the building.18. This apparatus shall be connected to a mains socket outlet with a protective earthing connection.17. To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug from the AC receptacle.ġ6. The plug on the power cord is the AC mains disconnect device and must remain readily operable. Servicing is required when the apparatus has beenĭamaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.ġ5. Refer all servicing to qualified service personnel. Unplug this apparatus during lightning storms or when unused for long periods of time.14. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.ġ3. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with theĪpparatus. Only use attachments & accessories specified by Rane.12. Protect the power cord and plug from being walked on or pinched particularly at plugs, convenience receptacles, and the point where it exits from the apparatus.ġ1. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.ġ0. The wide blade or third prong is provided for your safety. A grounding-type plug has two blades and a third grounding prong. A polarized plug has twoīlades with one wider than the other. Do not defeat the safety purpose of the polarized or grounding type plug.
#Serato dj pro rane 61 install
Do not install near any heat sources such as radiators, registers, stoves, or other apparatus (includingĪmplifiers) that produce heat.9. Install in accordance with manufacturers instructions.8.